Close

Coatings and Linings Inspection

Print Friendly, PDF & Email

RAE Engineering coating inspectors are trained to Level III certification status under the NACE International Coating Inspector Training & Certification Program (NICITCP).

Drawing on experience gathered over the past 20 years on three continents, RAE Engineering has been instrumental in the selection of and supervising the application of coating systems for aggressive environments and unusual applications for various clients.

Pipe Coating

Selection of a suitable system requires a sound understanding of the corrosion mechanism, operating conditions, the environment and the limitations imposed by equipment, location, climate and other external influences.

coatings-and-linings-inspection-2
Coating Failure

Objective inspection and control during the coating and lining application process is provided by trained and experienced professional staff. Critical phases of the process such as surface preparation, materials preparation (especially multi-component materials), materials application, and external environmental factors are monitored and recorded under the RAE Engineering internal Quality Assurance System.

Layers and Embrittled Urethane

Our inspectors are well experienced in this field, allowing them not only to monitor but also to advise clients and contractors on best possible practices, thus contributing positively to the cost-effective and satisfactory completion of a project.

Services
  • Specification preparation
  • Selection of systems
  • Shop inspections
  • Site inspections
  • Project management and supervision
With offices in Edmonton, Grande Prairie, Red Deer and Calgary, we are here to ensure that the needs of our clients are met.